Orlowski Lo-Pro

cranks have arrived and i have a chainring in my sights

build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it build it

oh and dibs crankset when u sell it

have yet to acquire the chainring, but when i do...

ffffuuuuuuuuuu pervious owner of the cranks neglected to mention that he had snapped off and rounded a ring bolt!

becuase they're one sided you can't get the bastard out easily either. Luckily I work in a engineering Dept. so come tuesday I will be paying a vist to the workshop boys to see what can be done.

refund? or have you already left positive feedback on ebayz?

i doubt i'll find any more of these cranks for under 40 quid. I'll try a bolt remover on tuesday and then if not i could always machine the support out get a new one put in, wont cost me anything, but hopefully it wont come to that.

what tyres are you getting? I just got my frame back from armourtex and will have the same problem with clearance. on the front mostly
though.

photo photo!!

gatorskin for the front and a gatorskin hardshell for the rear

heres a photo of a new addition:

I asked about the width, hence the clearance mention...

ah sorry 23c's

ffffuuuuuuuuuu pervious owner of the cranks neglected to mention that he had snapped off and rounded a ring bolt!

becuase they're one sided you can't get the bastard out easily either. Luckily I work in a engineering Dept. so come tuesday I will be paying a vist to the workshop boys to see what can be done.

how irksome! plus gas, heat and a thread extractor should do the trick

47t mavic chainring purchased, should fit perfectly with the cranks once i fix the sheered bolt problem.

Also white strong V's came for the risers, just waiting for the chain to come back in stock and cranks to be ready so i can sort the BB

Luckily I work in a engineering Dept. so come tuesday I will be paying a vist to the workshop boys to see what can be done.

Engineering dept of what? Lucky to have that access........

a university

Bolt has been extracted, cranks are ready to go, now I just need the bloody chain ring to arrive

i used my now pedalthreadless starfish with a 111mm veloce bb.. worked a treat.. they must be available in italian treat?! otherwise,i have some chorus italian thread sealed bb cups which I'ld part with.. fit centaur and chorus and probably record too..

were you using them with a single ring?

Yep! They are ISO, that's for sure..

banging i'll order a BB now

Has this been solved built yet? ;)

Updates plz

http://m.flickr.com/photos/41862722@N06/7218433002/
Papped (again)

Haha wtf?! ^

Called over to see spotter earlier and "spotted" it in the window