You are reading a single comment by @AngelD and its replies.
Click here to read the full conversation.
AngelD-
I've found similar here. These are basically 'boots' to stop dirt travelling up the cable.
Whilst one of those looks really similar to like the ones @Murphys_Law is using for fully-sealed, they're not the same. By the looks of it you'd not get the teflon tube through the smaller dia opening :-(
The pic you used @Murphys_Law, where is that from? I need those!
miro_o
@AngelD Thanks, but the problem isn't really the clamps themselves, as they have plenty of power. The problem is that the cable running between the two clamps on the toptube isn't taut but slack and therefore slacking around.
@miro_o No, not the entire length. That would only work with Nokon Style outer cables, as you mentioned. I run teflon tubing where the bare brakecable would be exposed, so between the two cable bosses on the top tube. I use Jagwire connectors to connect the outers to the tubing in a near watertight manner.
These endcaps have a liner that protudes. these connect to these rubber "rain covers"
which then connect to the teflon tube.
I'll take a picture of the setup on the bike tomorrow.