You are reading a single comment by @miro_o and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
miro_o
Murphy's_Law
@AngelD Thanks, but the problem isn't really the clamps themselves, as they have plenty of power. The problem is that the cable running between the two clamps on the toptube isn't taut but slack and therefore slacking around.
@miro_o No, not the entire length. That would only work with Nokon Style outer cables, as you mentioned. I run teflon tubing where the bare brakecable would be exposed, so between the two cable bosses on the top tube. I use Jagwire connectors to connect the outers to the tubing in a near watertight manner.
These endcaps have a liner that protudes. these connect to these rubber "rain covers"
which then connect to the teflon tube.
I'll take a picture of the setup on the bike tomorrow.