-
Just to clarify: you're using teflon tubing running the entire length of the cable inner?
This would work in Alligator iLinks (probably).
miro_o-
@AngelD Thanks, but the problem isn't really the clamps themselves, as they have plenty of power. The problem is that the cable running between the two clamps on the toptube isn't taut but slack and therefore slacking around.
@miro_o No, not the entire length. That would only work with Nokon Style outer cables, as you mentioned. I run teflon tubing where the bare brakecable would be exposed, so between the two cable bosses on the top tube. I use Jagwire connectors to connect the outers to the tubing in a near watertight manner.
These endcaps have a liner that protudes. these connect to these rubber "rain covers"
which then connect to the teflon tube.I'll take a picture of the setup on the bike tomorrow.
Murphy's_Law
I botched some together out of some Jagwire connector parts and 3mm teflon tubing for the exposed bit. works quite well on my Cross Check.
I can take a picture of it when I get home.
Its quite a cheap alternative as you can use any 5mm housing, and the parts you need are probably under £10