Which Groupset?

Posted on
Page
of 370
  • not a very heavy sleeper then

    it's like hippy in a bivvy

    chortle

  • Don't they come with those in the box?

  • Take the batteries off?

  • Missed this part in the article;

    For extended transportation, SRAM recommends that you remove the derailleur batteries and replace them with the red battery port covers to keep the battery contacts clean.

  • Yes, they do.

  • Theres a periodic recall system inplace. So you dont need to worry about seals degrading over time.........

  • For extended transportation, SRAM recommends that you remove the derailleur batteries and replace them with the red battery port covers to keep the battery contacts clean.

  • I bought Zipp 303. How long until I'm dead?

  • 13 minutes...

    12 minutes...

  • RIP @SeƱor_Bear, he'll be missed.

  • Still here fuckers.

  • I see dead people.

  • Apparently Etap sluggish rear shifting improves massively with use of a Shimano cassette

  • Apparently Etap sluggish rear shifting improves massively with use of a Shimano groupset

  • I haven't noticed it being sluggish and am using a Shimano cassette so there might be some truth in this.

  • Apparently they slowed the shifts down to conserve battery life.

  • Have you been happy with it so far?

    I may have accidentally hit the buy button last night.

  • I'm running it on a SRAM Red cassette. It can be fractionally slow for the chain to move after the derailleur has shifted; I wouldn't say the derailleur movement itself is actually slow. The speed of the chain following the derailleur can vary depending on which cog, it does seem a little reluctant down at the smaller end of the cassette. I wonder if this is where the Shimano cassette might help.

    I have spent many, many hours try to finesse the front derailleur position to avoid any slight chain rub on big chain-ring-biggest three cogs (not that I intend to use big-big but I'm a perfectionist and I want to know it would be spot-on if I did). In that respect, I think the Shimano model where the front derailleur trims itself is much better - Sram instead stubbornly insist the Yaw design means it isn't necessary, but it must have been possible to programme in. Mind you, I had pretty much the same problem with Red 20, so I wonder if I am towards the limits of bike geometry compatibility with Yaw anyway.

  • Yes, very. It all just works and the right hand to shift up, left hand to shift down set up is very intuitive.

  • Not pretty, is it?!

  • same same but different

  • No, it's not the new DA groupset.

  • Post a reply
    • Bold
    • Italics
    • Link
    • Image
    • List
    • Quote
    • code
    • Preview
About

Which Groupset?

Posted by Avatar for braker @braker

Actions