You are reading a single comment by @1000archangels and its replies. Click here to read the full conversation.
  • bump.
    I have managed to find some bolt-on novatecs wih solid high flange.
    I have spoken to a machinist (from on here) and he said that cutting the flange off to make it low should not be a problem, that will also allow for custom drilling 24h front/28h rear using the dividing head.

    the hub body is beefier at the flange sides, so it should not affect it structurally also.
    Will update the thread with the weight once this is done, quite possibly a bit will be shaved off the mid area too depending on couple of factors.

    stoked!

    http://i40.tinypic.com/2wfl44i.jpg

About