You are reading a single comment by @Todd and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Todd
So how was the geometry communicated in the first place?
What did you ask for Jimmy?
Same geometry but with sliding dropouts?
It seems to me they've taken the classic rear end (track dropout style) and switched out the dropouts without checking. I could be wrong.
It seems a very silly mistake from a top frame builder.
They'll definitely sort it for you so hang in there.
You don't need to use Bike Cad as the issue is obvious.
Make the rear end longer so you can use the sliding dropouts properly!
Not that hard to figure.
Make sure all your other specs are good first though...