You are reading a single comment by @Björn and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Björn
I'm about to order some spokes for the first time and was wondering if I'm doing it right..
I'm not sure what the ERD of my Corima Aero above is, as I don't know if there are any differences in the years they were build.
I found this on weightweenies:
ERD 553.0 mm and the inner diameter 544.0 mm
I measured the inner diameter of mine and it's the same, so is it fair to say the ERD will be the same too?
Am I then right on this?
Spoke hole: 2.6mm
Spoke circle: 62mm
Centre to flange left and right: 29.5mm
Holes: 24
Using the Edd spokecalc for lacing 2 x it tells 262.7mm
But the Corima Aero ERD implemented in the calculator is using 563.0mm ERD and tells 267.7mm
I'm not sure, but is the latter including nipples?
What length should I pick for internal nipples?
Cheers