Current Projects chat and miscellany

its not a lever... it's a dummy hood. There's a little hook thing (max unkindly called a 'flid lever') which I think just helps hold your grip when you get forward out of the saddle. It doesn't move/pivot. However something inside it rattled subtly like a mutherfucka till I sprayed shit loads of spraymount in there.

like this:
*Slide back the rubber hood cover from the front/top/pointy part.
This will reveal the top of the plastic decorative shroud.

*Use a small flat-blade screwdriver to gently pry the top of the
shroud down and out from under the top of the lever body. This will
snap out with very little effort.

*Once the shroud is off, you'll see a tiny setscrew just below the
pivot pin. It's either 2 mm or 2.5, I forget which. This setscrew
may be hard to turn, it's Loctited in place. Remove the setscrew.

*Push the pivot pin out to one side and all of the moveable parts
will come right out.

*Snap the shroud back in place, and replace the rubber hood. You're done!
?

sheldon