Any question answered...

You are reading a single comment by @hugo7 and its replies. Click here to read the full conversation.

•

lahdelah in reply to @hugo7

Yes, although after looking closely, turns out there's no thread, so might have to tape over it or any other suggestions welcome?

•

hugo7 in reply to @lahdelah

You can get these caps for hex heads

Find one that would fit tightly, clean the area, tiny dab of superglue on one side of the hole. Superglue is quite brittle so when you want to remove it, give it a little tap first.

Should be a very neat solution.

•

lahdelah in reply to @hugo7

Thanks! Edit..the screw head is be too big for clearance, so will have to try sugru.

About

Avatar for hugo7 @hugo7 started