You are reading a single comment by @lmamammal and its replies.
Click here to read the full conversation.
-
For stuff like this that IMO could have been a lot better designed:
Brake cable/hose goes under the BB but gear cable goes over. Just send them both the same way.
2x dt guides with large spacing is stupid. There is gonna be loads of cable slap at HT so will probably resort to BMX style zip tie up top. Needs 3x guides or additional guides on/near HT + BB
The removable guides are a PITA to route cables through and ‘clamp’ them. Free movement is better in case of crash.
1 x internal route only. Route all internal or don’t bother apart from the entry into ST for dropper.
Ok, 3+4 get you a very clean SS build but I reckon that is an extremely small percentage of Neutrino builds.
2 Attachments
lmamammal
How come? Seems like a lot of cost/hassle to make it less versatile.
What about getting some stainless grub screws and blue lock tighting them in? Should be less noticeable than the silver screws. I'm sure you could find a close nail polish to paint over the grub screws. That way with a bit of effort you can always reverse it.