Haha, unfortunately i had it wrong as this a boring old 135mm RS 505 hub.
is about 54mm
Ouch i was hoping to pair it with some Rotor 1X cranks that are around 44mm, doesn't sound like a good match to me. Would a 5800 crankset with a NW ring on the outer position and maybe a few shims work better? Chainline is listed as 43.5mm but i'm assuming that's measured between inner and outer?
Would also need to think about securing it properly, pretty sure i have an old XT qr somewhere but maybe there's a steel bolt up skewer that isn't trash like the Halo etc?
Front disc hub will be cheap and work great, with chain line between 41-46mm ish depending on dishing and spacers used. Convert with new threaded axle and a selection of spacers.
Haha, unfortunately i had it wrong as this a boring old 135mm RS 505 hub.
Ouch i was hoping to pair it with some Rotor 1X cranks that are around 44mm, doesn't sound like a good match to me. Would a 5800 crankset with a NW ring on the outer position and maybe a few shims work better? Chainline is listed as 43.5mm but i'm assuming that's measured between inner and outer?
Would also need to think about securing it properly, pretty sure i have an old XT qr somewhere but maybe there's a steel bolt up skewer that isn't trash like the Halo etc?