You are reading a single comment by @___freddie and its replies.
Click here to read the full conversation.
-
If the threads fit together like this (might have to take that rubber grommet off to check):
then they're probably the same, in which case you could cut the longer one down a bit to fit. In my experience plumbing threads are all over the shop with loads of "standards" in use, and that's not even counting manufacturer's own weird threads.
tl:dr - get a new spout from the same manufacturer, or get a new tap. Or maybe it'll fit with a trim. I'd bet the farm on no adaptor existing.
dbr
@___freddie
I wanted to swap out my too long spout for a shorter one but the threads on the existing are a lot shorter/tighter.
Can anyone identify if an adaptor exists that may work?
3 Attachments