You are reading a single comment by @Glws and its replies.
Click here to read the full conversation.
-
that's a proper project.
is it the same frame as the red one with the tight tyre clearances ?i think it should be 200£ onwards for a repair close to a bearing cup, hopefully just that
Glws-
I'm hoping that the experts come back and say it's no problem as the piece that's come off is tiny and mostly looks to be paint/lacquer - obviously keen to hear their thoughts...
It's the same geometry as the red Z5 but slightly older (Z4), mechanical only but has clearance for 28mm... and a monostay...
mattyc
Also - the issues, the fork currently has an Allen key jammed into the stuck and rounded out bolt head… that’ll need sorting, the shifter cable ferrules and cable ends are bonded/stuck in the stops, as is the rear mech housing… all still usable though so will build up with these if I have to… and finally, the major issue - there is a bit of chipped carbon on the underside rear of the head tube as pictured, so I’ll send some photos off to the experts for advice and quotes…