You are reading a single comment by @Brun and its replies.
Click here to read the full conversation.
-
Excellent. Sorry, realise I never replied to your email about ease of setting up but trust it was straightforward enough.
You might've read stuff about using a piece of paper to set the gap between nozzle and bed. I used that method for a while but found it vauge in terms of how thick or resistant to movement the paper should be. Instead, I found it much easier to shine a bright light from behind the nozzle and simply eyeball it as close as possible.
If you have any issues with print bed adhesion (or rather lack of), ScotchBlue masking tape seems to help. I've seen there are specific products which claim to as well, but haven't tried any myself.
Which slicer are you using?
Brun
Sam_w
Went with the eBay one , so thanks to you and @Brun for the recommendation.
Have printed the nut and bolt, and a little personalised lego brick which it did with zero issues. Now attempting to print a lego car stand. After that is some monopoly money organisers for my daughter...