Any question answered...

You are reading a single comment by @Howard and its replies. Click here to read the full conversation.

•

onyerbike

Rounded off the bolt attaching my old arm rests to the base bar. I have tried a torx head, and gingerly cutting a straight edge into it but not enough purchase. It was only ever tightened to 3-4nm.

What's the next step?

•

Howard in reply to @onyerbike

Hold the arm wrest, twist the base bar?

No good? Next try to do a better job of cutting a slot. Dremel with a disc will do it nicely.

Screw removal pliers if you can wait.

•

onyerbike in reply to @Howard

Thanks @Howard. I'll borrow a Dremel in the first instance - the cups just spin around but not enough to loosen.

About

Avatar for Howard @Howard started