You are reading a single comment by @vilms5000 and its replies. Click here to read the full conversation.
  • @vilms5000 you make a good case, the only issue is I’m not looking to get into any sort of trick skating, once I learn to cruise around.
    Fear of breaking bones/injuring myself is what’s tempering that route for me.
    But will have a think about it. BiL is round today so might have a play with his board and trucks and see..

  • No tricks, just 'moves'!
    Cruising around at a skate park might include rolling around a bowl. Carving (and not lifting your front truck to do anything other than get the nose over the coping as you exit...) is a valid reason to be at a park : )

    Up thread are lots of truck recommendations. The Indy 169 is the go-to for a deck like yours. But I'd look into cheaper Indy knock offs. Truck turniness is about the way the truck is set up (bushings, risers, placement), sure, but start with the truck geo.

    Lastly, for me, the key to a stable ride that turns and can be pumped on the flat (I use a sub-10" double kick, Indy 169s, 78a wheels) is the distance between the trucks. Measured from the inner edge of the truck baseplates, I like the 16.5 inches of trad vert decks, anything shorter feels squirrelly*. I'm 6' 3", so this is a factor, your mileage may vary!

    Edit: *I run my trucks loose.

  • Thanks for the advice, much appreciated.
    Last paragraph is just words to me. Makes me feel similar to when I first started on the forum and was asking about components to build my first frame. So much to learn and get my head round..

About

Avatar for vilms5000 @vilms5000 started