You are reading a single comment by @gbj_tester and its replies.
Click here to read the full conversation.
-
Is this actually documented by Shimano anywhere
Not anywhere I've seen, the service manuals assume you have half a clue what you're doing. The advice applies to any QR or through-bolt hub with adjustable bearings, you should account for the compression of the axle by the wheel installation in the frame/fork when setting the bearing clearance.
gbj_tester
dubtap
I was looking at how to properly adjust Shimano cup and cones after installing a new cone and according to a Youtube guy you should have a tiny bit of play that then gets taken out by the quick release.
Is this actually documented by Shimano anywhere or is it something people have found just works?