You are reading a single comment by @dubtap and its replies.
Click here to read the full conversation.
-
I was looking at how to properly adjust Shimano cup and cones after installing a new cone and according to a Youtube guy you should have a tiny bit of play that then gets taken out by the quick release.
Is this actually documented by Shimano anywhere or is it something people have found just works?
dubtap-
Is this actually documented by Shimano anywhere
Not anywhere I've seen, the service manuals assume you have half a clue what you're doing. The advice applies to any QR or through-bolt hub with adjustable bearings, you should account for the compression of the axle by the wheel installation in the frame/fork when setting the bearing clearance.
gbj_tester
Should new hubs always be 'buttery' smooth? Do they loosen a little when run in?
Reason I'm asking - I've just bought an XT hub (sold as 'new without packaging' on ebay from a guy who seems chilled) and it's immaculate, clearly never been built up nor had cassette anywhere near it. But I'd expect it to be a little smoother and looser i.e. it feels just a little tight and very, very slightly notchy, and the freehub just a little resistant. As my experience with new hubs is nil, just wondering if this is normal? Thanks.