You are reading a single comment by @atk and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
jellybaby
Brommers
@atk
What's the best way to cut a handful of curvy shapes (think shoe insoles) out of 2mm aluminum sheet?
I have a hacksaw, 1010W 115mm angle grinder and Dremel but no tin snips or jigsaw. Guessing angle grinder is probably overkill for such thin material. Just buy snips? Splash out on jigsaw? Probably going to end up getting a set of files to clean up either way.