ok, i have assembled shifters (9170) front mech (6870) and rear mech (grx 815) over the last few months. As I understand it, I need
EW-JC130mm (will sit in the down tube) EW-RS910 (bar end) SN-BCR2 BT-DN110 (seatpost)
Can anyone confirm that a) those bits all work together and b) I'm not missing anything?
thanks!
You need internal and external junction boxes and 2 cables for shifters the rest sounds fine
No need for an external junction box - the 910 bar end shifter does that job. You will need an internal A junction to tie everything together, and probably a Y cable for the bars if you're using the bar end junction box. Or a soldering iron.
@amey started
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
ok, i have assembled shifters (9170) front mech (6870) and rear mech (grx 815) over the last few months. As I understand it, I need
EW-JC130mm (will sit in the down tube)
EW-RS910 (bar end)
SN-BCR2
BT-DN110 (seatpost)
Can anyone confirm that a) those bits all work together and b) I'm not missing anything?
thanks!