You are reading a single comment by @M_V and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
gbj_tester
@M_V
If you want/need to build a wheel with different crossings on each side (3x driveside, 2x nds) there’s not much option other than to build one side at a time is there?
I normally build both sides at the same time (inbounds then outbounds) so dunno if there’s a way to lace it up that’d mean when you twist the hub the spokes in both flanges are at the correct angle? Like, send the 2x spokes straight out but put the 3x ones in at a bit of an angle?