Home DIY

You are reading a single comment by @tbc and its replies. Click here to read the full conversation.

•

Nef in reply to @tbc

showing an error code

Does it just say “error” or is it a specific code? Have you googled the model and some variation of the problem?

Ours wasn’t draining well, and was managing to spin a bit, but new brushes sorted the problem - although seems unlikely to be the same issue if yours is spinning ok.

•

tbc in reply to @Nef

It's this code, and I've tried all of these things to no avail:

https://www.zanussi.co.uk/support/support-articles/laundry/washer-dryers/washer-dryer-displays-error-message-e20-or-c2-emits-2-beeps-or-2-flashes/#:~:text=Issue%3A,It%20indicates%20pumping%20problems.&text=The%20appliance%20makes%20an%20unusual,blockage%20of%20the%20drain%20pump

Then I found this chat where it is suggested it might be a PCB fault:

https://www.ukwhitegoods.co.uk/forums/forum/public-support-forums/help-and-support/washing-machine-help-forum/69361-zanussi-e20-error-code-but-it-can-drain

•

musa in reply to @tbc

Had a similar on mine. Took filter and pump out.

Then a relative of mine think turned it on it’s side. And remove the drain hose, there’s a like a light ball similar to a soft play. And just moved that about

Seem to work

About

Avatar for tbc @tbc started