You are reading a single comment by @CYOA and its replies.
Click here to read the full conversation.
-
It did, I just haven't figured it out yet. I'm sure there's not much to figure out but one thing at a time - power tools are a mystery to me.
CYOA-
Its pretty self explanatory. Couple of tips:
- Ignore any scale on the bar of the fence, always take a measurement with a tape between the fence and the edge of the blade.
- Before doing your cuts, do a test cut on an offcut and measure this as well.
- When you get to the end of a rip pay attention as because the fence is ahead of the blade you can get some wobble.
- Ignore any scale on the bar of the fence, always take a measurement with a tape between the fence and the edge of the blade.
Bobbo
Did it not come with a rip fence? All you need for repeatable cuts.