Crafts / Craftsmen / craftswomen (craftspeople, I suppose)

You are reading a single comment by @Polygon and its replies. Click here to read the full conversation.

•

MisterMikkel in reply to @Polygon

Fusion is nice, but unless you are very experienced with stress analysis in CAD I'd leave it alone. It is much easier getting something wrong than getting something right, unless you know excactly what you're doing.

•

Polygon in reply to @MisterMikkel

Ok, I'll not bother with that aspect then. TBH I'm pretty sure the structure should be sound, it would just be a bonus to check.

•

MisterMikkel in reply to @Polygon

If you're used to woodworking, you probably already have a good idea about what'll hold and what won't.

There's just so many little aspects that influence the result of your simulation - better to do some full scale models or just over engineer whereever possible.

About

Avatar for Polygon @Polygon started