You are reading a single comment by @Hovis and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Hovis
I'd like a piece of pre-cut and finished MDF or Ply to make a desk top. roughly 90 by 55cm.
Is my best bet to suck up the £50ish cost of getting a local supplier to make it for me (or a less than local supplier to make it for me and ship it) , or is there a cheaper alternative that involves significantly less money at similar or lower levels of faff?