You are reading a single comment by @yoshy and its replies.
Click here to read the full conversation.
-
I didn't mean it was more than normal, just trying to describe the section where the tt tapers into the st. I just really like how it looks
yoshy-
Arrh I see.
Sorry, misread your comment.
But, yes you are correct. There is many solutions for this using lugs. Sam (stayer cycles) and I have been working on a seat tube lug similar to the one Donohue just released, but decided that this solution is more clean when fillet brazing anyways. The problem starts when you start tig welding this joint. I haven't found a solution for that yet.
Edit: I have thought about leaving it open and let rear cable come out through the hole
Hulsroy
Ta. It isn't that bad. I don't know the actually weight. I reckon it is a bit like a pair of forks or rear ends.