You are reading a single comment by @Acliff and its replies.
Click here to read the full conversation.
-
I’ve got a wavy washer to go on, which some research suggests is all that i’ll need. I’ve removed the preload collar and spacer so the force 22 crank should fit.
Tried my hollowtech spanner on the BB, no luck. As you say, the bearings don’t appear very well sealed but i’ll give them a go.
1 Attachment
-
Acliff
Have you eyeballed if you'll need spacers btw? Should be pretty straightforward to calculate.
Asking as anything Rotor is a pain in the pisser so it might be easier to change tack now... That said, I installed Rotor 3d+ on my steel bsa 68mm frame ok and didn't need any spacers bar a couple of turns on Rotor's built in adjuster on the non driveside crank so a wavey washer or two might just do it.