Electronic & Hydraulic Shifting (Di2, Ui2, customisations)

You are reading a single comment by @Jaap and its replies. Click here to read the full conversation.

•

hippy in reply to @Jaap

I'll see if I have anything that will work. You reckon DIY approach is better than the factory rubber mounts?

•

Jaap in reply to @hippy

I went for the DIY approach because my zipp seatpost is oval on the inside and I wasn't sure if the factory plugs would work with that.

•

hippy in reply to @Jaap

Yeah, same with the Shiv and the Kinesis has a customised Thomson but I'm going to try my S-Works Tarmac post which is pretty standard carbon 27.2. I'd rather get the best fit possible from the start rather than having to put it together and pull it down again for a take #2.

About

Avatar for Jaap @Jaap started