You are reading a single comment by @M_V and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@M_V
Initial set up will have been done before the inner had stretched and before the outer was properly seated in ferrules/ferrules seated in frame.
I always check mine immediately after doing anything with the cable (i.e. wheel removal where you've disconnected and reconnected the cable) and then again a few days later.
If you've ridden it to work etc, do it before you ride home. 2mm out sounds like a lot to me. I don't ride mine unless the edges of each dot are aligned.