1970/80s Peugeot roadbike project help

You are reading a single comment by @edscoble and its replies. Click here to read the full conversation.

•

BensBikeBits in reply to @russmeyer

erm.......
there is none. It was trial and error with the cable till I got the tension right.
If i get a little bit of rub I can deal with that. If it becomes an issue ill think of a way to sort it.
@PhilPub you sure will. The 11-25 is being swapped tomorrow for an 11-28 just to make it a bit easier.

•

edscoble in reply to @BensBikeBits

there is none. It was trial and error with the cable till I got the tension right.

WIthout compressing the housing?

11-25 is fine for Ditchling.

•

BensBikeBits in reply to @edscoble

Yeah I used the front mech. I held it in the position for the big ring then attached the cable. As I let go the mech drop down to the small ring by compressing the housing just the right amount. Works wonders on front and rear mechs.

About

Avatar for edscoble @edscoble started