You are reading a single comment by @Scilly.Suffolk and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Scilly.Suffolk
PhilDAS
my housemates Caad7 build (thread on here) is having a minor difficulty.
His rear wheel is a campag khamsin G3 and it fouls the drive side drop out. The cassette is on correct and has no play, doesn't need spacers but the mech hanger screws touch the lock ring and in the smallest gear, the chain rubs the frame.
Comparing visually to my shimano wheel, the nut holding the axle in sticks out further past the cassette on mine than his though I know they're different types of hub. Also without a skewer, there is still a couple of mm between the width of the axle and the dropouts so I think they need to be spaced a little bit. Any ideas?
I can post pictures if it helps