You are reading a single comment by @M_V and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@M_V
Anyone know if there exists a headset for standard press in cup, 1 1/8" diameter headtube that takes bearings that have 30.2mm ID and 45mm inner angle?
Basically I want to change the fork on my bmx but my bike is mid school and has the standard 1 1/8" headtube for press in cups and now that bmxs use internal headtubes/sets a lot of forks have an integrated crown race so if I could change my headset to a sealed bearing one running the same spec of bearing as the internal headset then it'd give me more fork options.