You are reading a single comment by @freezing77 and its replies. Click here to read the full conversation.
  • I've replaced the wheel on a friend's bike and had to cold set the frame and respace the rear hub to fit.

    Now the axle is too long for the QR to close properly, it is closing on the axle rather than the dropout so the wheel slips.

    Spacers on the outside of the dropout, or hacksaw to the axle?

  • File the axle rather than hacksaw, presumably you are only going to be taking off a millimetre or so.

About

Avatar for freezing77 @freezing77 started