Rotor cranks

You are reading a single comment by @Howard and its replies. Click here to read the full conversation.

•

Scilly.Suffolk

Meh.

With just an 11.5mm spacer (no 0.5mm washer and the pre-load adjuster backed right off) I can only torque the crank bolt to 20Nm before the bearings start to bind.

Does anyone have an 8.5mm spacer spare?

@amey Didn't you have one?

•

Howard in reply to @Scilly.Suffolk

I think headset spacers just drop straight in if you want to test that theory.

It was either those or off cuts from steerers - can't remember which.

•

Scilly.Suffolk in reply to @Howard

Thanks for the tip: I'll give it a whirl!

About

Avatar for Howard @Howard started