-
My sister had one BITD that was used and abused so I got good at XA repair (that was 15-20 years ago when my hands were steadier and eyes keener).
As you might imagine, things are tightly packed which can be intimidating, but it's nonetheless designed to be repaired so it's doable.
Do some background reading first - find a repair manual or look at some online teardowns etc to familiarise yourself with what you're doing
http://www.kyphoto.com/classics/repairmanuals.htmlI think I will look for some instructions how to take it apart and clean - anyone else done this?
Rik_Van_Looy-
thanks, they don't have XA2 guide but the top looks similar (awesome site). will have a look for more info definitely, before attempting anything!
found: http://www.rangefinderforum.com/forums/showthread.php?t=137072
hoefla
Yeah some poor decisions on my part. I went hoping for a cheap dev+scan, but got a not-very-cheap dev+print option.
The film is mostly not too bad - the same mix I use in the Leica and get processed at Photofusion, except the Kodak which I just bought when I was out and had run out. The light leak was from the first film I forgot was in the camera, I'd put it in and shot a few frames after fixing the light seals.
Good idea about slide film test and batteries. Until about a week ago daylight has been so dull anyway - surely even worse in Berlin?
To be honest, even with good exposures and processing they would still have been junk, which is what is most disappointing. I can't "rest" my finger on the shutter button without it firing, so I have to drop and press. At the same time I often can't get it to fire when I actively press down so I then have to make two or three attempts. I read that this may indicate some dirt under the shutter button? I think I will look for some instructions how to take it apart and clean - anyone else done this?