You are reading a single comment by @svenhöek and its replies.
Click here to read the full conversation.
-
Will it work if I use a a rear cone in a front hub (same 10mm axle size but front uses 3/16 ball bearings where as rear is made for 1/4).The rear cone would have a more open curve, so it should be possible?
It will work for about 5 minutes, then your balls will explode. The rolling elements in the bearing might not last long either :-)
gbj_tester
@svenhöek
Shimano cup and cone hubs:
Will it work if I use a a rear cone in a front hub (same 10mm axle size but front uses 3/16 ball bearings where as rear is made for 1/4).The rear cone would have a more open curve, so it should be possible?
I want to do this for reasons :)