You are reading a single comment by @Cranky and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Cranky
You've just made me realize that if the bearings are 6000-2RS the ID is 10 mm therefore a 9x1 axle would be no use.
I assume, although hope I'm wrong, that the axle shoulder provides support to stop the inner section of the cartridge bearing shifting with respect to the outer.
May be I should simplify my question to does anyone know where I source an after market axle for such a hub?