Most recent activity
-
- 7 comments
- 2,319 views
-
I'm currently deciding on a new build, a bit of a show pony to be honest. I'm looking at two frames, the first is the Blackwell low pro from 14 bike co and the second is the Dosnoventa Barcelona. I have never seen either in the flesh, they both look sweet. Does any one have any pro's or cons on either frame before I part with some hard earned lolly!
Thanks...
-
Fade, are you still in Newport or the Shire? Have you moved back to the smoke? I can't believe I didn't reply? I cant apologize enough. I'm based out in Broseley.
-
I have checked the Sram Omnium chain line it's 41mm. So I'm going to space out the drive side of the crank by 2mm. That gives me 43mm, to use with the Goldtec hub spacing of 42.5mm. That all should work very well...thanks again!
-
Hi, can any one give me a little advice? I want to fit Sram omnium track cranks on my Dolan pre cursa. I'm also fitting Goldtec track hubs as part of this new build. I'm just wandering will the crank need spacing on the drive side, to get a perfect chain line with out any fouling?
Cheers! : )
-
A vintage mens road racing frame, 20.5 inches/52 cms. Reynolds or Columbus tubing preferred, must be in good structural condition and no rust. Not to fussy on colour, as this will be resprayed. The frame must be able to take a 700c wheel set as well. Sorry I can't collect but will pay for all postage! Cheers! : )
-
Are there any fixed riders in the Shire? Am I the only sole individual who is? Communication, rides, exchange of ideas...and beers/social?! : )
That's a fair call, and handmade in the midlands too. I was actually just looking at replacing the steel fork with a columbus minimal 1 inch carbon.