Roberts Micro lopro frame project

Roberts Micro lopro (were used with long seatpost ) 700c rear wheel.
Top tube approx 56cm ctc and 51cm ctt seattube.
I bought for the forks for another project - started to prep frame for repaint but just too busy.
There was a fair bit of light surface oxidization under paint which has been rubbed back and treated,
Small bit of filler discovered on downtube (few mm) slight indentation there.
No further use to me so selling as project -brazing practice fodder - or for frame tossing competition (it's very light Columbus EL) Ritchley dropouts.
£20 pick up only (absolutely can't post -sorry) High Barnet.

4 Attachments

Im interested! PM

2nd dibs

brazing fodder?? frame tossing???? It's a Roberts EL frame!!!! That's criminal...
good on you though for passing it on to someone who can rehabilitate the finish....

No follow ups from interested parties. I have added close up of damage - looks like a puncture or very small, hard indentation as would be done with a centre punch. Has a very hard filler in it (not car body filler) . I really need to get shot of this to make space in front room so £10 collected ( prob best to wait until snow has receded)

1 Attachment

What size seatpost does it take?

27.0 I think - I dont actually have a 27 to try but 27.2 is to large and 26.8 is looser than the ideal push fit.

What size front wheel ?

Was a 700c - it is one of the micro type lopros so 56 cm tt but low and used with longer seatpost to give that aggressive geo

Dibs