Mat-CR
pizzarat
platypus
Post a reply
About
Several Suntour XC Front hub
Posted by
@hacha
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
NOS unboxed without QR, Suntour top range for MTB.
-4 available in 32
-3 available in 36
20 € each
"The XC PRO hubset employs the Wilderness Trail Bike's GreaseGuard bearing concept to provide trouble free, low maintenance use over a long life. XC PRO hubs begin with a one- piece, forged, aluminum hub shell. The front hub shell is drilled through for the axle, then bored from each side to recess the bearing cartridges. The hub shell is high polished, leaving a mirror-like finish. The bearings are the Japanese IKS 6001RS that have been modified, so that outer seals yield slightly near the axle which allows older grease to be pushed through in the area around the axle, to the outside where it can be conveniently wiped away, without wheel removal. A small "Zerk" type fitting inside each hub flange permits grease to be injected into the backside of the bearing. The rear seal has been modified to permit grease to pass through the back toward the front."