26mm Campagnolo Cassette Lockring

Thanks

Is that the 9/10 speed one? I have an 8 speed one lying around that you can have, but I suspect the sizing is different.

Was starting to lose hope, thanks...

I'm after the 26.0 mm lockring (width of thread) with 38.5mm flange for 12T smallest cog. There was a 26.0 mm campag lockring with 35.2mm flange for 11T smallest cogs. Further reading.

To be honest I'd be take either 26mm campag lockring as quite desperate.

Perhaps this would work then. It's Miche, but I was using it on a 12-28 'nolo 8 speed cassette.

1 Attachment

Thanks! If you can confirm the diameter of the thread on the reverse is 26mm I'm interested!

Yeah, looks like it. If not, it's annoyingly close. The typical (Italian) bike part conundrum. You're welcome to take it and give it a try.

Just a bump if I'm allowed - unfortunately the 2 lockrings I've sourced through the forum are too big unfortunately.

i have a couple of old campag cassette lockrings in my parts box. can't remember the details as not looked at them for a long time. will check them tomorrow morning and you are welcome to have them for free if they are what you need

Many thanks!

Fiddlesticks, sorry it didn't work out for you. Good luck with the search.

Thanks very much for the help!

I have a campag lockring (from a NOS 8-sp cassette) that strangely didn't fit the freehub... just measured with calipers and the outside diameter at the threads appears to be 28.5mm - I assume that means its not the same one you need then, unless I am measuring the wrong thing? happy to measure again if it's ID or something else...

Is it going on an 8 speed wheel or 9 up?

9 speed