Wanted: Bar End Plugs

I am in need of a pair to plug the ends of my sawn-off riser bars. they're super sharp and are scratching the buggery out my flat (albeit at a proportionally pleasing dado level). trouble is the internal diameter (or hole if you prefer) is only 14mm, or maybe 15mm if I file off the sharp bit. My Primo and Federal ones are too wide. Anyone got anything going spare in exchange for some pounds or something of mine? preferably black and new(ish).

Thanks a lot.

Please no rectum-related replies!

go to your lbs, sholdn't cost u too much

nothing that'll fit :(

file those barbs off, ya lazy git

suerly, the ends would be the same width as un-chopped bars???
so any mountain type bung/plug should fit? some grips come with bungs,no?

or just get ourys

the diameter is the same as the ends were yes, but they have mega-thick alloy walls. the plugs that came with the (bmx) grips didn't fit for example.

they were cheapo.

@ chris, can I borrow a file?! still need to get them covered up cos they're leaving silvery snail-trails on me walls... got some black Soyo grips on standby (thanks Brian)...

arse!

i'm 3000 miles away at the moment other wise i would come help out

Nicholas ARSE!

PLUG?

I have Amoeba bars like that, with 5mm wall thickness. You need a skinny plug. I'm sure if you ask enough shops you'll track 'em down or try measuring the diameter and just look around for something to match.

Any use?

Champagne corks - just trim them down to fit.