Polo Bikes

You can tark...

ftfy

Dem tyres

i love that bike.

Made a polo bike disc brake guard out of a £1.50 frying pan and a chunk of strip steel.
Without the steel it would just bend into the rotor on the first impact, but with it its very sturdy.
Mounts on the QR axle (I have narrow fork dropouts so its not a problem) and the lower IS disc mount hole, however if I'm going to run the BB7 or Deore mechanical calipers i'll have to cut a load more off it, looking to try an Avid juicy which have a very low profile, hopefully will tuck in behind - hence upcut for now.

Completely encloses the 160mm disc rotor with about 10mm overlap toward the wheel so impossible for fingers/shin guard straps/mallets/QR levers getting in there.
Total cost about £1.75/ 60 minutes

more worried about my calliper than my rotor tbh

more worried about my calliper than my rotor tbh

How so?

Seen a crash resulting in bent rear IS mounts before, but so was the frame.

I'm more worried about getting a finger in a spinning rotor.

I'm more worried about ruining my sweet stickers.

Needs moar lazers...

Frying pan disc guards can get the fuck out, janky ass mother fuckers. Why not use a chopping board for a saddle while you're at it?

Lol.

Why not use a chopping board for a saddle while you're at it?

As long as you use the appropriate board, what's the problem?

Ladies may differ, but I guess the guys will want a mix of red and brown for their meat and two veg.

the guys will want a mix of red and brown for their meat and two veg.

This is too far for even me.

lolz

ha chan.

Y u no fasten caliper to disc tab?

Y u no fasten caliper to disc tab?

Genuine weight saving NoBoltz.
Read OP ;)

New shoes for the Charge; what has been a budget build so far...£5 for the frameset and a lot of free/cheap parts...

I'm more worried about getting a finger in a spinning rotor.

2008 called, it wants its bitching back.

^ the ghost of polo past.

More troll than ghost.

Frying pan disc guards can get the fuck out, janky ass mother fuckers. Why not use a chopping board for a saddle while you're at it?

Yeah, because fuck diy. If you're not paying top dollar for purpose-built parts, you don't belong in bike polo.

Nailed it

How many players in the top division of the league haven't had at polo specific frame?

Sean... Anyone else?

Most of them I would say