You are reading a single comment by @allensea and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@allensea
I had to space my threaded cog out a little too. 2 x 1mm spacers. Didn't lost quite that much thread as the bit right next to the hub isn't threaded.
Also had to flip the front sprocket over to line it up with the rear and give it enough clearance from the chainstay.
Other than that mine all fit perfectly into an All City Big Block. Wheel is right in the center of the track-ends with the belt tensioned and I can get the belt off easily enough at the front.
Definitely need to make some careful measurements if you are retrofitting it to avoid an expensive mistake.