-
Saddles, seatposts etc.:
[strike]1 - Scape (Cube OEM) saddle [strike]£4[/strike]** >>> £3 sold Brameses– Good nick, grey and black (+ red underneath), looks a bit like a wide short Arione [/strike]
2 - Carrera saddle [strike]£3**[/strike] **>>> £2/nice beer **Dibs sacredhart – Fairly big and comfy, slight tear at the nose.
3 - Ridgeback saddle [strike]£5[/strike]** >>> £4** – Barely used, swapped off a bike very shortly after purchase. Well padded.
[strike]4 - San Marco rolls saddle £5 **sold christono **– Mauve, pretty ratty, rails are rusty and it has a couple of holes towards the back. Still comfy though[/strike]
[strike]5 - Push seatpost £5 **sold **jackbepablo – silver, 26.4mm, 300mm from rails to minimum insertion mark. Pretty scratched but shiny towards the top[/strike]
[strike]6 - Scape (Cube OEM) seatpost [strike]£5[/strike]** >>> £4 sold TTM** – grey, 31.6mm, 270mm from the saddle rails to the limit mark, quite a nice 2-bolt clamp design. It's lost some of the anodising, but has no deep scratches.[/strike]
[strike]7 - Kalloy suspension seatpost £3 sold to peck123 – black, 27.2mm, 250mm from rails to minimum insertion mark. Recently stripped and serviced, boings as it should.
8 - Old-school steel seatpost £5 sold antlers – 25.4mm, about 100mm from rails to minimum insertion mark.
9 - Silver QR seat clamp FREECYCLED– for a 34.9mm seat tube as far as I can work out.
10 - Selle Royal saddle £7 **Dibs antlers **- Grey, moderately ratty. Has some paint splatter and two small tears (both visible in 2nd photo below). The cover has some dents at the back where I used pegs in re-gluing to the base, but these may disappear with use.[/strike]Wheels
[strike]Shimano/Mavic 700c front wheel £20** >>> £17.50** now front wheel only >>> £10 sold gino – Shimano RX100 hub laced to Mavic 190 NE 1er Monte/OEM rim with stainless spokes.[/strike] Rear RX100 hub available below.
[strike]Maillard/Raleigh 700c front wheel £10** >>> £8**>>> £7 sold sacredhart – Maillard hub laced to Raleigh chromed steel rim with rustless spokes (36). The rim has a few rust spots but is in generally good condition and runs nice and true. The hub is in good condition and I've just repacked it so it spins smoothly. Includes rim tape, tube and a gumwall tyre that may be usable (can’t guarantee). I think this didn’t see much use before being stored. The matching rear hub is listed below (#3) so could be useful for someone building a SS wheelset.[/strike]
Sachs/Sunn rear 26” (MTB) wheel £12 Sachs Sunn hub, Sunn rim (made by Rigida), 135mm OLN, will take a 9-speed Shimano cassette. Nice and true, spins smoothly but is not perfectly buttery, minimal wear to braking surface. Quite a nice wheel really. Comes with innertube and Innova 1.6 semi-slick/town tyre with plenty of life left.
2 Attachments
-
-
[B]Hubs etc.
[/B][strike]1 - Tektro security skewers £3 front/back pair sold teekayboy[/strike]
2 - Selection of QRs £1/beer each
3 - Maillard rear hub [strike]£5[/strike] >>> £4 – 36H, Good condition as with the front wheel listed above, little used before dismantling and storage. Complete with bearings and track nuts
[strike]4 - Quando rear hub FREECYCLED – 6-bolt disc brake mounting, 135mm width. Has been laced but in good condition, spins smoothly and the freehub works nicely.
5 - Shimano RX100 rear hub FREECYCLED - Matches the front wheel above, but I dismantled this from the wheel as the rim was shagged. 125mm width but could be spaced to 130mm. Just repacked and turns nice and freely. The freehub clicks nicely and fits a Shimano 7-speed hyperglide or uniglide cassette (it might be compatible with more speeds). [/strike]
/attachments/71755I also have a few bundles of spokes, mostly galvanised from dismantling some old 700c wheels. Might be useful for someone repairing or building wheels. Postage or beer money depending on your mood. PM me for details.**
Drivetrain **
[strike]1 - Shimano RX100 derailleurs **rear [strike]£6**** >>> £5[/strike] >>> £4 sold evo533; £3 front sold Shandoom **– I think these are 2 x 7, but could be compatible with other setups. A bit grimy but move freely.[/strike]
[strike]2 - Shimano RX100 cranks £5 **soldstaylor688 **– 170mm, 130mm BCD. One of the chainring bolt holes has a crack next to it. This shouldn’t impair their function, but priced as beater fodder accordingly. Threads and tapers are fine.[/strike]
[strike] 3 - Shimano Biopace chainrings £5 (the pair) sold knyazb – 52/42 teeth pretty well used, but have a bit of life left[/strike]
[strike] 4 - Shimano 7-speed Hyperglide cassette £5 **sold knyazb **– 13-23, good condition, includes lockring[/strike]
5 - Shimano 9-speed Hyperglide cassette £3 – 11-32, a bit worn bit still shifts well, includes lockring
[strike]6 - Surly 14T 1/8” track cog [strike]£8[/strike] >>> £7 sold ltc – Very good condition, no wear that I can see.[/strike]
[strike]7 - Shimano Deore thumbshifters £8 **sold Tris **– decent condition and functionally fine. Right hand shifter is friction or SIS (7-speed).[/strike]
[strike]8 - Cyclo Campagnolo bottom bracket tool £3 sold Tris
9 - Adjustable (left-hand side) cup and cone BB cup WITHDRAWN– Includes lockring, might be useful for ghetto-style fixed on a SS hub (I do not endorse this!)[/strike]
[strike]10 - Double chainring bolts £1/beer per set– 2 sets, 1 Sakae sold hms. Rusty but fine 1 Shimano sold knyazb[/strike]
[strike]11 - Campagnolo cartridge bottom bracket £1/beer sold chrisbmx116 – 68mm shell, 111mm axle. Turns smoothly but the mangled cups have seen much better days.
12 - Look Carbon pedals (2nd photo) FREECYCLED - Old school clipless! These spin freely, if not smoothly, and the cleat retention bits spring back and forward as they should.
13 - Campagnolo Avanti front mech for braze-on (3rd photo) [strike]£5 >>> £4[/strike]** >>> £3** sold thegreatbelow - Good condition, non-original cable clamp bolt [/strike]/attachments/66865
/attachments/67529Frame & forks fully for free (an ale always abundantly appreciated)
[strike]Cannondale steel frame 56cm square gone jackbepablo.
Raleigh steel forks 250mm 1” threaded steerer gone mrgumby These are bent. Cold setting them might be possible, but I take no responsibility if you choose to ride on them! (I replaced them specifically because I didn’t know how big a knock they’d taken).[/strike]
3 Attachments
-
-
• #6
2nd dibs mx levers
-
Photo for Park:
Internal bolt surfaces are all good, so no problem with tightening or releasing. 15cm long.
1 Attachment
-
-
Dibs campag bb!
-
dibs on the shimano rx100 cranks, threaded headset and the 2 od the tektro brakes will pm now
-
Just picked up a set of brakes, top chap...
-
Yo are those MX levers I dibsed still going?
boggy
Park
sacredhart
knyazb
chrisbmx116
staylor688
Christono
Jakowlew
harv4130
xWOODYx
Shandoom
martyn1
s1mon-
Post a reply
About
For Sale: Clearout (inc. forum donation) – most types of components, some freecycle + updates
Posted by
I finally finished my build so I’m clearing out some surplus stuff. I’ll be adding some more items once I’ve had time to check, clean and service them, so check back. 10% will go to the forum once I’ve sold a decent amount of stuff. PM me for more details or pictures. I’m open to offers on multiple items.
Pickup ideally in central (WC1) London during the week. Larger items (frame, wheels) will have to be picked up elsewhere in London, PM me if you’re interested. I can post small items within the UK at cost.
Bars, stems, headset:
[strike]1 - Raleigh drops £10 sold davis9 – nice shiny silver, 395mm CTC at the end of the drops. Some marks from brake levers, but otherwise very good condition and really light (260g).[/strike]
[strike]2 - Amoeba DH handlebar [strike]£7[/strike]** >>> £6 sold Brameses**– silver, 675mm wide, 22.2mm (BMX) or 25.4mm clamp diameter with included shim. Good condition, AL6061 T6 5mm walls, probably unbreakable.[/strike]
[strike]3 - BBB flat handlebar £5 sold boggy– black, alloy, 560mm wide, 25.4mm clamp diameter. Nice and light, one or two marks, but no gouges[/strike]
[strike]4 - SR Custom quill stem **£3 sold s1mon **– 100mm CTC, to fit 1" steerer, 25.4mm handlebar clamp. Has some scratches including one deep one around one side of the clamp. Functionally fine though.
5 - Black alloy adjustable stem FREECYCLED – 130mm (at 0 degrees), 0 – 60 degree rise, to fit 1 & 1/8” steerer and 25.4mm handlebar.[/strike]
6- Quill stem bolt and wedge £2/nice beer – for 1” steerer (22.2mm), 15cm long, close up photo below.
[strike]7 - Headset spacers £1/beer sold Jakowlew – 1 & 1/8”, 2 x 10mm, 2 x 5mm[/strike]
[strike]8 - Threaded headset FREE sold teekayboy – 1”, this runs pretty smooth but is a bit odd. The frame cups are ISO, but the crown race appears to be JIS. I’ve included another crown race which is ISO, but I can’t guarantee compatibility once it’s all fitted.
9 - Brand new Charge griddle grips WITHDRAWN - Gum coloured with matching bar end plugs. These are the special edition ones with the clear, rather than white, core (second photo)[/strike]
/attachments/66853
**
Brakes:**
[strike]1 - Brand new Tektro front calipers £4 each (£3 for the one without pads) – Recessed allen bolt fitting. Sold x 1 Christono; x 2 staylor688; x 1 sirbikealot [/strike]
[strike]2 - Raleigh calipers **£10 (the pair) sold dicki **– silver, nut fitting. These appear to be rebranded Weinmann 500s. A bit rusty on the fittings, but will shine up. Includes pretty new Weinmann pads and a pair of reflectors on nice substantial metal brackets. These need a bit of cleaning up too but would look good on a shopper or town bike.[/strike]
[strike]3 - Shimano RX100 Super SLR (BR-A550) calipers, front/back pair £5 sold srocha – silver, recessed allen bolt fitting, 39-49mm drop. These are used but still function ok. The cable adjuster doesn’t work on one of them, but could be fixed if you find an adjuster with the correct thread. Includes pads with a fair bit of life left.[/strike]
4 - Dia-Compe centre pull £3 – Copy of the Weinmann 610, nice and shiny. Includes nut and radius washer. Includes the old-school blocks (#9).
5 - Shimano cantilevers £4 – good condition, includes shimano M55/T wet/dry blocks for aluminium rims with a fair bit of life left in them and a shimano straddle cable
[strike]6 - MX flat bar levers £3 sold boggy– black, decent condition.
7 - Pair of old school drop bar levers **FREECYCLED **– silver. One has a suicide lever attached, but this can be removed and they’ll still work fine
8 - Old school drop bar lever left-side only FREECYCLED – Good condition, with suicide lever.
9 - Old-school blocks **WITHDRAWN **– look almost new
10 - V-brake pads WITHDRAWN.[/strike]
/attachments/66854
**
Mudguards:
**[strike]Crud RaceGuards (front & back pair) WITHDRAWN - Nearest 2 items in the photo. Good condition, I'll throw in some zip ties as well (wooooooo!)
Crud RaceGuard rear WITHDRAWN - Furthest item in photo. Slightly longer, slimmer version of the rear mudguard. A bit faded but still in good nick.[/strike]
/attachments/67535
[strike]Levi's Silver Tab Modern Boot Fit Jeans W36 L34 £10 sold El_Diablo
[/strike][strike]Wildly off trend jeans. Their coolness is only slightly elevated by the fact that they were bought in San Francisco. I haven't worn these much as they're a bit big and I'm trying not to "grow into" 36" waist trousers. Obviously worn away at the heels but otherwise good condition.[/strike]
3 Attachments