You are reading a single comment by @ChadTheInhaler and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@ChadTheInhaler
Shite. Put the carbon spacers on and sat the stem on top. But no matter how i adjust, re-assemble, apply pressure, swap stems i cannot get it all tightened without an irritating bit of play in the steerer. I have assembled the sealed bearings etc as fsa advise. But when all is tightened up and i lift the front end the forks move. Could Planet X have fitted the headset wrong? I doubt it. The bottom sealed bearing doesnt seem to fit snug over the crown race, it merely rests leaving a slight gap of a couple of mm. Surely i dont have to get another headset fitted. I am getting really frustrated with this.