You are reading a single comment by @Rik_Van_Looy and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Rik_Van_Looy
My Bob Jackson is 26.8 OD standard 531 and takes 27.0.
I've always just assumed that because track frames are supposed to be rock-hard they just reamed them out less.
I UTFS'd this out of general interest and came up with this.....
27.2mm became the standard seat-post size because most high-end road frames in the 1970s and 1980s were lugged and were almost universally made out of Columbus SL or SLX or Reynolds 531. These seat tubes were 1-1/8” in diameter, or 28.6mm. The single-butted seat tube was 0.9mm thick at the bottom and 0.6mm thick at the top. Well, 2x0.6mm = 1.2mm, which, when subtracted from 28.6mm, yields an I.D. of 27.4mm. However, the tolerance on the wall thickness and roundness of the seat tube made it so that you rarely could fit a 27.4mm post inside, even before brazing. And then, the seat tube always got distorted during brazing, making it even less possible to fit a 27.4mm in there, but a 27.2mm fit nicely. The same goes for why a 27.0mm seat-post was often used on the bigger sizes, which were made out of Columbus SP or SPX, whose seat tubes had 1.0 X 0.7mm wall thicknesses. Because of tolerances, the predicted 27.2mm post (28.6 – 2x0.7 = 27.2mm) never fit, but a 27.0mm fit nicely