Goldtec Hubs

I feel like i'm going round in circles with this hub business. I currently own a pair of 700 Chukkers laced to Goldtec hubs. These - http://http://www.tokyofixedgear.com/products/58-Hubs/616-Goldtec---Track-Hub-Front---Raw/?bc=no?bc=no

My question is whether these hubs will fit into the dropouts of a Volume Thrasher Frame and Fu Manchu forks. I think the axle size may be too small. If it is, can the axle be changed to accommodate a larger dropout, or are there adapters?

Any advise would be great.

oops http://www.tokyofixedgear.com/products/58-Hubs/616-Goldtec---Track-Hub-Front---Raw/?bc=no?bc=no

Yeah they're fine.
The thrasher was pre the 14mm thing so it's a standard 3/8 dropout.
any track hub will fit it.

post some pics when your build is done.
it sounds tasty

Damn that's a relief, I thought for a moment i'd have to spend a whole load more on new hubs. And yeah, I'm going to make a build thread I think, just on the look out for some forks now.

BMX pegs are out of the question?

they will fit fine

thread ends.

Why does the thread have to end?

When you say "they will fit fine", do you mean the Hubs, or bmx pegs?

there female axles so pegs should be fine, though i'm not sure since its an aluminium bolt

i'd say no to pegs...
it might work but the bolts arent designed for it so can be prone to bending or snapping...

but some light use of em shouldn't hurt em too bad...

Alright, i'll give it a go I think. Even if I don't use them too much, I guess they look good aesthetically speaking.
Thanks for the help