You are reading a single comment by @adam77 and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@adam77
I have a beater / pub bike frameset that's too small for me. Maybe of interest to someone? It's a Viscount Sprint in silver, a not bad lugged frame by the makers of the Aerospace, etc. Horizontal dropouts, brake guides on top tube but no canti or downtube shifter bosses so would potentially make a nice clean conversion.
Seat tube 50cm CTT
Top tube 52 CTC
Rear dropout spacing 120mm
Someone has tried but obviously failed to get the bottom bracket out - I don't think it's seized in though. No reason to replace anyway as far as I can tell. The headset's a bit wobbly - probably needs tightening up or overhauling, I'm not sure which (my expertise kind of stops short of headsets).
£15 collected from NR3.
(I hope I've posted this properly and not as a reply to someone else's thread - not sure if this was the right way to do it. If it's wrong, sorry... can re-do)